Step 1: PICK THE DIAGRAM FROM THE PDF DOCUMENT THAT MATCHES YOUR SET-UP AND ANSWER THE QUESTIONS BELOW. REFER TO THE DOCUMENT IF YOU NEED HELP MEASURING YOUR DRIVE SHAFT LENGTH.
Which diagram matches your set-up?
What is your drive shaft length?
STEP 2: ANSWER THE FOLLOWING QUESTIONS ABOUT YOUR U-JOINT SERIES IF APPLICABLE. PLEASE REFER TO THE MEASURING DIAGRAM AND NOTE THE DIFFERENCES IN MEASURING IF YOU U-JOINT CAP HAS TABS OR DOES NOT HAVE TABS.
What is your U-joint cap diameter?
What is the cross distance (between tabs or between flats)of the U-joint?
STEP 3: PROVIDE THE FLANGE MEASUREMENTS BELOW IF APPLICABLE. YOU WILL NEED TO REFERENCE THE MEASURING DIAGRAM IN ORDER TO GIVE US THE CORRECT DIMENSIONS.
What is the pilot diameter or distance "A"?
What is the bolt circle diameter or distance "B"?
What is the horizontal length or distance "C1"?
What is the vertical length or distance "C2"?
Are the bolt holes threaded?
STEP 4: PROVIDE YOUR VEHICLE'S YEAR, MAKE, AND MODEL.
What is the vehicle year?
What is the make of the vehicle?
What is the model of the vehicle?
STEP 5: PLEASE ENTER YOUR CONTACT INFORMATION BELOW AND ANYTHING ELSE YOU WOULD LIKE US TO KNOW BEFORE SUBMITTING YOUR ORDER.